Commissioning Procedure; Measurements - flamco meibes MeiTronic LFC Montage- Und Bedienungsanleitung

Commissioning procedure

The setup wizard can be accessed in menu 7.2 at any time.
Observe the explanations for the individual parameters on the following pages and check, if further settings are
necessary for your application.

1. Measurements

1. Set language and time
2.
a) Select or
b) skip
the commissioning help/setup wizard.
The setup wizard guides through the necessary basic settings in the cor-
rect order. Each parameter is explained in the control
display. Pressing the 'esc' key takes you back to the previous setting.
b) With free commissioning the settings should be made in the following
order:
Menu 3. Time, date and operating times.
l
Menu 5. Heating circuit settings, all values.
l
Menu 6. Protection functions (if any adjustments are necessary).
l
Menu 7. Special functions (if any adjustments are necessary).
l
3. In the menu operating mode '4.1. Manual', test the switching outputs
while the consumers are connected and check that sensor values are
plausible. Then set to automatic mode.
Measurement values serve to display the current measured temperatures.
If 'error' appears instead of the measurements, a temperature
sensor may be a defective or incorrect.
If the cables are too long or the sensors are not well-placed, small
deviations in the measurements may occur. In this case, the dis-
play values can be compensated by adjustments in the controller
- see 'Sensor calibration'. The selected program, connected
sensors, and the specific model design determine which meas-
urements are displayed.
11