Wall Installation - flamco meibes MeiTronic LFC Montage- Und Bedienungsanleitung

Wall Installation

8
Install the controller near the pump groups.
1. Unscrew cover screw completely.
2. Carefully pull upper part of the housing from
lower part. During the removal, the brackets are
released as well.
3. Set upper part of housing aside. Do not touch
the electronics.
4. Hold the lower part of the housing up to the
selected position and mark the three mounting
holes. Make sure that the wall surface is as
even as possible so that the housing does not
become distorted when screwed on.
5. Using a drill and size 6 drill bit, drill three holes
at the points marked on the wall and push in the
wall plugs.
6. Insert the upper screw and screw it in slightly.
7. Fit the upper part of the housing and insert the
other two screws.
8. Align the housing and tighten the three screws.
Connect the electrical system
1. Open terminal cover.
2. Strip cables a max. of 55 mm of the cables,
assemble the strain reliefs, strip wire ends 8-9
mm (Figure 1)
3. Open the clamps with a fitting screwdriver (Fig-
ure 2) and connect electrical system to the con-
troller.
4. Remount clip room cover and close by using the
screw.
5. Turn on mains supply and operate the con-
troller.