Building Up The Operating Pressure; Spraying - Parkside HG01829 Bedienungs- Und Sicherheitshinweise

Note: Before you open the container
pull the safety valve
release any residual pressure still present
in the container
5
Note: You can unfold the feet
bottom of the bottle to have extra stability.
D raw the pump
2
container
.
5
N ow fill the container
Note: Fill the container
the amount of liquid that you actually
need for that particular spraying session
(not more than 5 l).
Lock the pump handle
cover . Place the pump
2 a
the container
5
handle clockwise as far as it will go.
1
Building up the
operating pressure
T urn the pump handle
to unlock it before pumping.
M ove the pump handle
until the pressure sprayer has been
pumped up to a pressure not exceeding
the maximum permissible operating
pressure of 2.5 bar. To ensure this value
is not exceeded, monitor the pressure
gauge during the pumping process.
4
Note: If the pressure of the air in the
container exceeds 2.5 bar, the pres-
5
sure is automatically released through
the safety valve
3
P ress the pump handle
into the recesses and turn it clockwise
to lock.
N ow take the spray tube
holder.
Note: Unfold the feet
the step surface for better stability when
pumping on the ground.
5
to the side to
3
.
at
15
out of the
.
5
with only
5
to the pump
1
back into
2
and turn the pump
anti-clockwise
1
up and down
1
.
downwards
1
out of the
8
and stand on
15
F old up the feet
,
"PUSH" button if you are pumping when
carrying the product on your shoulder.

Spraying

H ang the pressure sprayer over your
shoulder by the carrying strap
Note: Ensure that the pressure sprayer
is always kept upright. Only when held
in this orientation will the sprayer work
properly.
H old the spray tube firmly by the han-
dle and direct the adjustable spray
11
nozzle e.g. at a plant.
7
Note: You can rotate the spray head
to change to different spray function:
Straight line (Fig. B1), Mist (Fig. B2),
Shower (Fig. B3), Rainfall (Fig. B4).
There are three movable section con-
nected to the spray head, so that you
can adjust to an appropriate angle for
spraying (Fig. B).
P ress the trigger
process.
R elease the trigger
ing process.
Note: When the pressure in the con-
tainer is no longer sufficient to spray,
5
pump the container
pressure again up to but not exceeding
the maximum permissible operating
pressure of 2.5 bar. You can check the
operating pressure using the pressure
gauge
(see "Building up the operat-
4
ing pressure").
P ull the safety valve
far as it will go to release the residual
pressure in the container
by pressing the
15
.
6
to start the spraying
13
to stop the spray-
13
to increase the
5
to the side as
3
(Fig. E).
5
GB/IE 17