Before Using; Inserting / Replacing The Batteries; Start-Up; Switching On / Off - Parkside PLEM 20 A1 Bedienungs- Und Sicherheitshinweise

Before using


Check the consignment for completeness and for signs of
visible damage.
Remove all packaging material from the product.

Inserting / replacing the batteries

When the low battery icon
can still make measurements. As soon as the battery icon turns
empty , however, you must replace the batteries. Measure-
ments are no longer possible.
Open the battery compartment cover
down the battery compartment cover latch.
Remove the used batteries from the battery compartment, if
necessary.
Insert the (new) batteries. Ensure the correct polarity as
shown on the diagram inside the battery compartment
Replace the battery compartment cover
(fig. A).

Start-up



Switching on / off

To switch the product on, press the MEAS button
When the product is switched on, the laser beam is activated.
To switch the product off, press and hold the MEAS button
for approx. 5 seconds until the "OFF" is shown on
4
display. If no button is pressed for about 3 minutes, the
product turns off automatically to save the batteries.
12 GB
appears in the display
by gently pushing
5
5
, you
3
.
6
as shown
.
4