Operation - Cameo Q SPOT 40 COLD WHITE Bedienungsanleitung

7
OPERATING KEYS
MODE – press MODE to access the selection menu for system settings. Press repeatedly to go back to the main display. ENTER – press
ENTER to access the menu levels to make value changes, and to access the sub-menus. Confirm value changes by pressing ENTER. UP and
DOWN – select individual menu items in the selection menu (DMX address, operating mode etc.) and in the sub-menus. Allow changes to
the value of a menu item, such as the DMX address as required.
8
EYELET FOR SAFETY CABLE
Overhead installation may only be carried out by qualified personnel. A suitable safety cable must be fitted to the spotlight's securing lug to
ensure that it does not fall down.

OPERATION

PLEASE NOTE:
• As soon as the spotlight is correctly connected to the power supply, the following will be displayed in succession: "Software Update
Please Wait..." (only for service purposes), "Welcome to Cameo", the model name and the software version. After this process, the spotlight
is ready for operation and starts in the previously selected mode.
• If the DMX operating mode is activated and there is no DMX signal at the DMX input, the display will start to flash after a few seconds.
• After approximately 30 seconds of inactivity, the display will automatically show the currently active operating mode.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure that allows direct access to previously
selected menu items and sub-menu items. 1. Press MODE and ENTER simultaneously for direct access to the last-edited sub-menu item, where
you can make changes instantly as required (DMX starting address and all modes). 2. Press MODE for direct access to the last-selected and
last-edited menu item. Press ENTER to access the last-selected and last-edited sub-menu item (DMX starting address and all modes).
CONFIGURING DMX START ADDRESS
Press the MODE button repeatedly until "Menu DMX Address" or "Menu Mode" appears in the display. If necessary, select the menu item
"Menu DMX address" by using the buttons UP and DOWN and press ENTER. Using the UP and DOWN buttons, select the desired DMX start
address and press ENTER to confirm. The DMX mode will be activated simultaneously.
Menu
ENTER
DMX Address
UP/DOWN
SETTING OPERATING MODE (Mode)
Press the MODE button repeatedly until "Menu Mode" or "Menu DMX Address" appears in the display. If necessary, select the menu item "Menu
Mode" by using the buttons UP and DOWN and then press ENTER. Now select the desired operating mode with the buttons UP and DOWN and
confirm with ENTER (see tables, note sub-menus). The comprehensive DMX table can be found in these instructions under "DMX CONTROL".
Operating Modes
Mode DMX = DMX operating mode
Mode Sound = Sound control mode
Mode Slave = slave mode
Mode Static = setting a "scene" without an external
controller
6
DMX ADDRESS DMX ADDRESS
-
001
ENTER
510
03CH = 3-channel mode
Sound = spotlight reacts to bass impulses. Adjustable
microphone sensitivity.
Slave = connect DMX IN on the slave unit to DMX OUT on
the master unit (same model) and enable one of the
standalone modes on the master unit. The slave unit
will now follow the master unit.
Static = master dimmer, fine dimmer, strobe (strobe function
as in channel 3 in DMX mode) can be configured
separately.