Ethernet; Establish Communication - AXXAIR SAXX-210 Originalbetriebsanleitung

INNOVATIVE ORBITAL SOLUTIONS

7. Ethernet

7.1. Establish communication

It is possible, at any time, to plug / unplug a network cable on the Ethernet port of the SAXX to establish
communication with a computer system.
After connecting the network cable, it is also necessary that the IP address of the SAXX and the network
match. There are 2 possibilities for this: either modify the IP address of the SAXX, or modify the IP
address of the computer.
- To see SAXX IP address:
1
- To modify SAXX IP address:
1
- To modify computer IP address:
The procedure depends on the type of material you are using. Here is an example of configuration with a
"Windows 10" computer:
Join experience
Start the SAXX. Once on the identification screen,
press in the top left corner and then in the bottom
right corner less than 0.5s later.
If the operation was successful, you should see a
gray banner appear at the bottom of the screen.
Press "1/3", then "IP Addr".
2
Start the SAXX. Once on the identification screen,
press in the top left corner and then in the bottom
right corner less than 0.5s later.
If the operation was successful, you should see a
gray banner appear at the bottom of the screen.
Press "Offline", "Main Unit", "Ethernet". Then it is
possible to modify the IP address and the subnet
mask.
Then press "Exit", and "Save changes and exit".
2
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
English
2
1
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 89 -