AXXAIR SAXX-210 Originalbetriebsanleitung Seite 83

INNOVATIVE ORBITAL SOLUTIONS
4D Rotation axis - Board
temperature
4E Rotation axis - Functioning
4F Rotation axis - Direction
4G Rotation axis - No speed
4H Rotation axis - wrong
speed
4J Rotation axis - Motor
temperature
Cooling unit alarms
5B Cooling unit - Flow
Cooling unit – Temperature
5C
Wire axis alarms
6A Wire axis - Communication
6B Wire axis - Current
6C Wire axis - Voltage
Wire axis – Board
6D
temperature
6E Wire axis - Functioning
6F Wire axis - Direction
6G Wire axis - Speed
AVC axis alarms
7A AVC axis - Communication
7B AVC axis - Current
7C AVC axis - Voltage
AVC axis – Board
7D
temperature
7E AVC axis - Functioning
AVC axis – Tube side
7L
sensor
AVC axis – External side
7M
sensor
OSC axis alarms
8A OSC axis - Communication
8B OSC axis - Current
8C OSC axis - Voltage
OSC axis – Board
8D
temperature
8E OSC axis - Functioning
OSC axis – Machine side
8L
sensor
OSC axis – External side
8M
sensor
Join experience
Electronic board temperature too high. Let it cool down.
Idem 4B/4C.
System detects a movement in the wrong direction.
Idem 4B/4C.
Idem 4B/4C.
Machine temperature too high. Let it cool down.
No flow or too low flow. Switch cooling connectors. Check that
hoses are not too much bended. Check quantity of liquid into the
tank.
Coolant temperature too high. Let it cool down.
Idem alarms 4 (rotation axis)
Idem alarms 4 (rotation axis)
AVC touched an end stop during a cycle. To avoid this problem,
use the "go to the middle" function before launch welding.
Idem alarms 4 (rotation axis)
OSC touched an end stop during a cycle. To avoid this problem,
use the "go to the middle" function before launch welding.
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
English
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 83 -