AXXAIR SAXX-210 Originalbetriebsanleitung Seite 56

INNOVATIVE ORBITAL SOLUTIONS
Ethernet port:
It is possible, at any time, to plug / unplug a network cable on the Ethernet port of the SAXX to establish
communication with a computer system.
WARNING: All the following connections must be made with the power off:
Welding machines connection:
Refer to welding machine or adaptation cables user instructions.
Wire feeder connection:
Refer to wire feeder user instructions.
AVC-OSC connection:
Refer to AVC-OSC user instructions.
Manual torch connection:
Trigger to start and stop welding must be connected on the AUX connector between contact 1 and 3:
Oxygen meter connection:
The contact to start welding must be connected on the AUX connector between contact 1 and 3:
Manual torch and oxygen meter use same contact so it is not possible to use them at the same time.
Join experience
Power source only knows if level of oxygen is
acceptable or not. It does not know the value of
oxygen rate.
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
English
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 56 -