Checchi & Magli FOX DRIVE PLUS Bedienungs- Und Wartungsanleitung Seite 81

planting quality constantly. In the event of anoma-
lies, stop the tractor moving forwards and adopt
corrective measures (see "Information on adjust-
ments" and "Troubleshooting"- pages 18 and 36).
NOTICE
In case of reduced plant spacing, we recommend di-
sassembling the extension (G) to prevent the over-
turning of the newly-planted seedling.
Night-time work or poor visibility conditions
Working at night or in poor visibility conditions increases
the risks arising from machine use; in these conditions,
Transporting the work vehicle
WARNING
For work vehicle loading/unloading, use lifting
equipment with a suitable capacity for the load to be
lifted.
Use all possible caution when lifting to avoid damag-
ing the work vehicle and causing injuries to persons
involved in operations.
Strap up the unit at the lifting points envisaged by the
manufacturer.
See the strap-up points and lifting procedures in the sec-
tions titled "Lifting the FOX DRIVE PLUS" on page 14 or
"Lifting the FOX DRIVE PLUS DT" on page 15.
Anchor the work unit to the means of transport with
ropes and secure the wheels with wedges.
UN41 0646MN
Proceed as outlined below.
1) Start the tractor and lift the work vehicle as far off the
ground as is permitted.
2) Get into the means of transport from the tractor's
driving seat.
3) Lower the work vehicle onto the truck bed.
English language
INFORMATION FOR USE
Follow the instructions provided herein to disassemble
the extension.
1) Unscrew the nut (F).
2) Remove the extension (G).
3) Tighten the nut (F).
4) Repeat the same procedure to remove the other ex-
tensions.
proper lighting must be provided to ensure safe work.
Units which are narrower than the maximum width al-
lowed by the Highway Code can be loaded , coupled to
the tractor, onto suitable means of transport using load-
ing ramps.
WARNING
Thoroughly clean the ramps and loading platform
before boarding the vehicle.
Position the ramps on the transport means and fix
them in a stable way to the truck bed using the fas-
tening devices (pins, screws, chain etc.).
Where the ramps meet the truck bed there is a dan-
gerous bump so move the machine very carefully
over this point.
4) Off the tractor engine and engage the parking
brake.
5) Anchor the work unit -tractor assembly to the means
of transport with ropes and secure the wheels with
wedges.
6) Affix the relative signalling signs to any parts jutting
out from the means of transport.
33
6
Use and maintenance