Checchi & Magli FOX DRIVE PLUS Bedienungs- Und Wartungsanleitung Seite 57

Information and safety signs
WARNING
Check that all the plates are legible; if they are not,
clean them or - if they are damaged - replace them,
applying the new ones in the same place as the old
ones.
C
FOX DRIVE PLUS
G
UN41 0624MN
A) Hazard plate: read the use and maintenance manual
before using the work vehicle.
B) Hazard plate: do not remain on the seat with the
work vehicle lifted off the ground.
C) Hazard plate: switch off the tractor; remove the igni-
tion key and store in a safe place before carrying out
any type of work on the work vehicle.
D) Information plate: strap up at the anchor points
shown to lift the work vehicle.
E) Information plate: lubricate the chain inside the
casing to which the plate is affixed.
F) Information plate: hook up the work vehicle at the
points shown to lift it.
G) Information plate: this indicates rotation of the part
English language
TECHNICAL INFORMATION
D
A
C
E
H
The illustration shows the locations and meanings of the
signs affixed.
B
D
L
M
to which the plate is applied, showing the direction
required to achieve the desired effect.
H) Plant spacing plate: this shows the type of pinion to
fit according to the plant spacing required.
L) Plant spacing plate: applied on the "right Rapid
Shift" wheel, it indicates the pinions to be selected,
according to the plant spacing.
M) Plant spacing plate: applied on the "left Rapid Shift"
wheel, it indicates the pinions to be selected, accord-
ing to the plant spacing.
The plant spacing plates applied are in relation to the
number of grippers.
The plates (E - G - H - L - M) are fitted on every planting
unit.
9
2
F
FOX DRIVE PLUS DT
BUDR O ( O)
BU RIO BO)
Use and maintenance