Checchi & Magli FOX DRIVE PLUS Bedienungs- Und Wartungsanleitung Seite 63

Lifting (FOX DRIVE PLUS DT)
WARNING
During lifting watch out for the load swinging, as
the hook-up point is never perfectly at the centre of
gravity.
Lifting operations must be carried out using suitable
means for the load to be lifted, by qualified and author-
ised personnel in order to safeguard their own safety
and that of the other people involved in the operations.
FOX DRIVE PLUS DT/2
FOX DRIVE PLUS DT/3
FOX DRIVE PLUS DT/4
UN41 0627MN
To lift the work vehicle, proceed as follows.
1) Before lifting check the stability of the harness.
English language
INFORMATION CONCERNING HANDLING AND INSTALLATION
FOX DRIVE PLUS DT/5 FOX DRIVE PLUS DT/6
The machine is equipped with lifting plates marked with
appropriate signs.
The illustration shows the points for lifting the work ve-
hicle.
The lifting procedure shown applies for all the work ve-
hicle models specified in the manual.
The FOX DRIVE PLUS DT/5 - FOX DRIVE PLUS DT/6 -
FOX DRIVE PLUS DT/7 models must always be hoisted
separately to avoid damage to the frame and possible
injury to persons involved in the operations.
FOX DRIVE PLUS DT/7
2) Strap up the work vehicle or separate units as shown
in the figure.
15
4
Use and maintenance