Disconnecting; Standby / Measuring Battery Voltage - ULTIMATE SPEED ULGD 5.0 B1 Originalbetriebsanleitung

Using the device
Disconnect the minus pole connection cable (black)
„
of the vehicle from the minus pole of the battery first
before charging and maintenance charging if the
battery is continually connected in the vehicle. The
minus pole of your battery is usually connected to the
car body of the vehicle.
Then disconnect the plus pole connection cable (red) of
„
the vehicle from the plus pole of the battery.
Only then connect the "+" pole quick-contact connec-
„
tion terminal (red)
charger to the "+" pole of the battery.
Connect the "–" pole quick-contact connection terminal
„
(black)
14
mains cable
charger
1
z Disconnecting
Disconnect the device from the mains current.
„
Disconnect the "–" pole quick-contact connection
„
terminal (black)
Disconnect the "+"-pole quick contact-connection
„
terminal (red)
Reconnect the plus pole connection cable of the battery
„
to the plus pole of the battery.
Reconnect the minus pole connection cable of the
„
battery to the minus pole of the battery.
z Standby / Measuring battery voltage
After connecting the mains supply, the device is in standby
mode. The standby display
connection terminals are connected, the battery voltage is
displayed in the LC display (voltage display
segments of the status display
ured voltage is below 3.8 V or above 15 V, then this
means the battery is not charging. The error message
"Err" will be shown briefly in the display. The device
switches to standby.
98
of the car and motorcycle battery
13
to the "–" pole of the battery. Connect the
of the car and motorcycle battery
12
to the socket.
from the "–" pole of the battery.
14
from the "+"-pole of the battery.
13
GB/MT
lights up green. When the
3
are empty. If the meas-
9
). The
10