Herunterladen Inhalt Inhalt Diese Seite drucken

Using The Device; Connection; Disconnecting - ULTIMATE SPEED ULGD 5.0 C1 Originalbetriebsanleitung

Kfz-batterieladegerät
Vorschau ausblenden Andere Handbücher für ULGD 5.0 C1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Contact the manufacturer via the indicated service address. Remove
all protective films and other transport packaging. Check that the de-
livery is complete.
Always pull the mains plug from the socket before you perform any
work at the car and motorcycle battery charger
Before connecting the charger please read the user instructions for
the battery.
In addition, you must adhere to the instructions from the vehicle ma-
nufacturer where a battery is continuously connected in the vehicle.
Secure the car or motorcycle, switch the ignition off.
Clean the battery poles. Make sure that the dirt does not come into
contact with your eyes.
Make sure that there is sufficient ventilation.
NOTE: The ambient temperature is measured in the charger. Hence, for
optimum function, make sure the battery exhibits the same temperature as
the environment.
z Using the device
z Connection
NOTE:
Always observe the instructions from the vehicle manufacturer or the
battery manufacturer.
Disconnect the minus pole connection cable (black) of the vehicle
from the minus pole of the battery first before charging and mainte-
nance charging if the battery is continually connected in the vehicle.
The minus pole of your battery is usually connected to the car body
of the vehicle.
Then disconnect the plus pole connection cable (red) of the vehicle
from the plus pole of the battery.
Only then connect the „+" pole quick-contact connection terminal
(red)
of the car and motorcycle battery charger to the „+" pole of
13
the battery.
Connect the „–" pole quick-contact connection terminal (black)
the „–" pole of the battery. Connect the mains cable
and motorcycle battery charger
If the output terminals are connected in reverse the red LED reverse
polarity
2
z Disconnecting
Disconnect the device from the mains current.
Disconnect the „–" pole quick-contact connection terminal (black)
from the „–" pole of the battery.
Disconnect the „+"-pole quick contact-connection terminal (red)
from the „+"-pole of the battery.
Reconnect the plus pole connection cable of the battery to the plus
pole of the battery.
Reconnect the minus pole connection cable of the battery to the mi-
nus pole of the battery.
lights up.
to the socket.
1
GB/IE/NI
.
1
of the car
12
15
to
14
14
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis