Disconnecting; Select Charging Mode And Start Charging Process - ULTIMATE SPEED ULG 17 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Operation
of the car charger to the socket.
7
Note: If the connection terminals are
connected correctly, the digital display
indicates the voltage and the "connected"
display lights up. In the event of reverse
polarity, the display will show 0.0 and the
reverse polarity LED
red in the digital display
z Disconnecting
Disconnect the device from the mains cur-
„
rent.
Disconnect the "–"-pole quick con-
„
tact-connection terminal (black)
the "–"-pole of the battery.
Disconnect the "+"-pole quick contact-
„
connection terminal (red)
"+"-pole of the battery.
Reconnect the plus pole connection
„
cable of the battery to the plus pole
of the battery.
Reconnect the minus pole connection
„
cable of the battery to the minus pole
of the battery.
z Select charging mode
and start charging process
You can choose from different charging
modes to charge different batteries.
As compared to conventional car battery
chargers, this device has a special function
for reuse of a flat battery/rechargeable
battery. You can recharge a completely
discharged battery/rechargeable battery.
Protection against wrong connection and
short circuit ensures safe charging. The
integrated electronics do not start the car
battery charger at once after connection of
the battery, but only after a charging mode
has been selected.
If the connection terminals are connected to
the battery and the device is connected to
the mains, the digital display
12 GB
6
will light up in
.
6
from
4
from the
5
will show
6
the "Connected" display. Once the charging
mode has been selected with the charge
start button 3 , the "Charging" display will
light up. When charging is complete, the
"Charged" display lights up.
If the digital display "0.0" is continually lit
before the battery is completely charged,
there is a defect.
In this case, check again if the connection
„
terminals ,
4 5
the battery and whether the correct bat-
tery type has been chosen. If the display
continually shows "0.0", there may be a
defect in the battery.
Reactivation function /
reconditioning: If a voltage between 8.5 V
and 10.5 V is detected in the connected
battery, the device will automatically start a
reconditioning process in order to reactivate
the battery. If a voltage between 8.5 V and
10.5 V is measured after the reconditioning
process, then "Err" will be shown on the
digital display. In this case, the battery is
faulty and must be replaced.
Note: This function is only available
for 12 V batteries.
Digital display button
switch between the digital display of the
voltage and charging progress in percent
(BATTERY %). Use this button to switch
between the following displays:
Battery %: shows the charging progress
„
of the connected battery in percent.
Voltage: shows the voltage of the
„
connected battery.
Alternator % check: Output power of the
„
alternator in percent.
Battery type button
to set the battery type to be charged. You
can choose between different battery types.
The battery type must be correctly set before
are correctly attached to
: Enables the
1
2 : Use this button