Disconnecting; Standby / Measuring Battery Voltage; Battery Recognition; Revival - ULTIMATE SPEED ULGD 10 A1 Originalbetriebsanleitung

z Disconnecting
Stop charging using the battery
clamps:
Disconnect the device from the
„
mains current.
Disconnect the "–" pole
„
quick-contact connection terminal
(black) from the "–" pole of the
21
battery.
Disconnect the "+"-pole quick
„
contact-connection terminal (red)
rom the "+"-pole of the
19
battery.
Reconnect the plus pole connec-
„
tion cable of the battery to the
plus pole of the battery.
Reconnect the minus pole connec-
„
tion cable of the battery to the
minus pole of the battery.
Stop charging using loops:
Disconnect the device from the
„
mains current.
Pull out the plug, which connects
„
the output with the plug
the connecting cable with loops
.
17
Cover the contacts of the connect-
„
ing cable with loops
attached cover cap of the connect-
ing cable with loops
with
15
with the
17
.
16
z Standby / Measuring
battery voltage
After connecting the mains supply,
the device is in standby mode. The
display is in use. When the connec-
tion terminals are connected, the
battery voltage is displayed on the
LC display (voltage display
segments of the status display
empty. If the measured voltage is
below 2 V, then this means the
battery is not charging.
z Battery recognition
If a battery with a voltage over 2 V
is connected, the charging process
will start once the charging program
is selected. Deeply discharged bat-
teries can also be charged, as long
as they are not defective.
If a battery with a voltage of over
15.6 V is connected, in 12 V mode,
"Err" will be shown in the voltage
display . The charging process in
11
24 V mode.
If the charger is connected to a
battery with the poles reversed,
"POL" will be shown on the display.
The charging process will not be
activated.
z Revival
After battery recognition, depend-
ing on the battery status, the revival
process will be activated. Pulsating
Using the device
). The
11
are
10
GB/IE/NI 17