Environmental Conditions; Disposal - Mettler Toledo XPR26PC Benutzerhandbuch

AC/DC adapter (model no.
FSP060‑DIBAN2):
Cable for AC/DC adapter:
Balance power consumption:
Polarity:
Protection and standards
Overvoltage category:
Degree of pollution:
Standards for safety and EMC:
Range of application:

Environmental conditions

The limit values apply when the balance is used under the following environmental conditions:
Height above mean sea level:
Ambient temperature:
Temperature change, max.:
Relative air humidity:
Acclimatization time:
Warm-up time:
The balance can be used under the following environmental conditions. However, the weighing performances
of the balance may be outside the limit values:
Ambient temperature:
Relative air humidity:
The balance can be disconnected and stored in its packaging under the following conditions:
Ambient temperature:
Relative air humidity:

7 Disposal

In conformance with the European Directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE) this device may not be disposed of in domestic waste. This also applies
to countries outside the EU, per their specific requirements.
Please dispose of this product in accordance with local regulations at the collecting point specified for electrical
and electronic equipment. If you have any questions, please contact the responsible authority or the distributor
from which you purchased this device. Should this device be passed on to other parties, the content of this
regulation must also be related.
22
Input: 100 – 240 V AC ± 10%, 50 – 60 Hz, 1.5 A
Output: 12 V DC, 5 A, LPS, SELV
3-core, with country-specific plug
12 V DC ± 10%, 2.25 A
II
2
See Declaration of Conformity
Use only indoors in dry locations
Up to 5000 m
+10 − +30 °C
5 °C/h
30 − 70%, non-condensing
At least 8 hours after placing the instrument in the same location
where it will be put into operation.
At least 120 minutes after connecting the balance to the power
supply. When switched on from standby, the instrument is ready
for operation immediately.
+5 − +40 °C
20% to max. 80% at 31 °C, decreasing linearly to 50% at
40 °C, non-condensing
-25 − +70 °C
10 − 90%, non-condensing
Pipette Calibration Balances