Medium Priority Errors - Inogen ONE G5 Technisches Servicehandbuch

5.4. MEDIUM PRIORITY ERRORS

The following medium priority error messages are accompanied by a triple beep and a flashing yellow
LED.
Display
O2
O2
VERTRAULICH und 96-09302-00-01 Rev.
GESCHÜTZT
Text Condition
Equivalent
Oxygen Error Oxygen <50% for 10
minutes.
No Breath No breath has been
Detect detected recently.
Check
Cannula
Battery HOT The battery temperature
has exceeded the
Warning
temperature limit while the
concentrator is running on
battery power.
System is not delivering
O2 Delivery
boluses correctly.
Error
System Hot Concentrator has
Warning exceeded temperature
limit.
DCR 20-328
C
Action/Explanation
The concentrator has stopped producing its
normal amount of oxygen. If this error
persists, replace the concentrator.
The concentrator will produce automatic
pulses of oxygen at a constant breath rate.
Check that the cannula is connected, that
there are no kinks, and that the cannula is
positioned properly in the user's nose. Once
an adequate breath is detected, the unit will
exit adaptive autopulse mode and the
message will be cleared.
The audible alert associated with this error
will only occur when No Breath Detect mode
is enabled. The user can disable this mode
by holding down the mode button for 2
seconds until the LCD displays a bell with an
X through it.
Move the concentrator to a cooler location or
attach the unit to external power and remove
the battery to cool. If this error persists,
replace the concentrator.
Remove power and the battery and restart
the concentrator. If error persists, replace the
concentrator.
Move the concentrator to a cooler location.
Ensure air intake and outlet vents have clear
access and particle filters are clean. If this
error persists, replace the concentrator.
08. Oktober INOGEN ONE G5 TECHNISCHES
2020 HANDBUCH
Seite 18 von
42