Residual Risks - Parkside POFA 12 A1 Originalbetriebsanleitung

Materials hazardous to
health such as lead, materi-
als coated in paint containing
lead or materials containing
asbestos may not be worked
on using this device!
• Fasten and secure the workpiece
by means of clamps or with
another method on a stable un-
derground. If you hold the workpiece
only with your hand or against your own
body, it will stay instable and this can
lead to a loss of control.
• The permissible rotation speed of
the attachment tools must be at
least as high as the highest rota-
tion speed indicated on the pow-
er tool. Accessories that run faster than
the permissible speed can be destroyed.
• Cutters and other accessories
must be exactly matching the
tool holder (collet chuck) of your
power tool. Attachment tools that are
not exactly matching the tool holder of
the power tool rotate unevenly, vibrate
very strongly and can ultimately lead to
a loss of control.
• Ensure that the cutter is assem-
bled correctly. A cutter that is not as-
sembled correctly can break during the
milling or be ejected and present a risk
of injury.
• Move the power tool against the
workpiece only when it is turned
on. Otherwise, there is a risk of kick-
back if the attachment tools jam in the
workpiece.
• Do not put your hands in the
cutting area and neither on the
cutter. Hold the upper handle
or the motor housing with your
other hand. When holding the milling
cutter with both hands, they cannot be
injured by the cutter.
• Never mill over metal objects, nails
or screws. The milling cutter can be dam-
aged and lead to increased vibrations.
• Use suitable detectors in order to
find hidden supply lines or ask
the local utility company. Contact
with electrical cables can lead to electric
shock and fire, contact with a gas pipe
can result in an explosion. Damage to
a water pipe can lead to property dam-
aged and electric shock.
• Do not use any blunt or damaged
tools. Blunt or damaged tools can
cause uncontrollable situations.
• Hold the power tool tightly with
both hands while working and en-
sure a secure footing. The power tool
is guided more securely with both hands.
• Wait until the power tool has
stopped before placing it down.
The attachment tools can jam and lead
to a loss of control over the power tool.
• Avoid contact with the tool or
the workpiece immediately after
processing. The parts may be hot and
cause burn injuries.
• Use only milling cutters which have the
correct shank diameter and are suitable
for the speed of the power tool.
• Do not use any accessories
that are not recommended by
PARKSIDE. This can result in electric
shock or fire.

Residual risks

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
GB MT
49