SPORTSTECH Power Rack FPR300 Bedienungsanleitung Seite 30

Step 2
1. The pedestal frames must be aligned so that the two holes for the lower frame connector point to
the rear and the flat connectors on the side for the frame rails point outwards.
2. Screw the lower frame connector to the feet with four screws (5), four washers and four nuts. Make
sure that the U-profile points upwards in the middle.
3. Place the frame rails on the stand frame and align the holes with the flat connectors. Fasten the rails
and stand frame with three screws (6), six washers, three nuts and a flat connector each on the
inside.
7
5
6
5
6 5
6
6
Lower frame connector
Flat connector to the outside.
9
8
7
5
6
30
9
8
6 (12x) (M10x65)
5 (4x) (M10x65)
6
6
Holes to the rear.
6 5
6
5
6 5
6
5