Care And Maintenance - Collomix Xo 20 NC Originalbetriebsanleitung

EN Work at a reduced speed when immersing the machine
into or removing it from the mix. Once the machine has
been fully immersed, increase the speed to the max-
imum so that sufficient motor cooling is guaranteed.
Guide the machine through the mixing vessel during the
mixing process. Mix until all the mix has been complete-
ly worked through. Observe the material manufacturer's
processing instructions.
The tougher the mixture, the higher the torque forces
acting on the machine; prepare yourself for this during
work.
Recoil may occur if the running mixer comes into con-
tact with a surface (e.g. base of the bucket).
Battery pack
Charge the battery pack before use. Recharge the bat-
tery pack if the performance drops.
The ideal storage temperature is between 10°C and
30°C.
If the battery capacity has been depleted, the machine
remains at a standstill. Re-insert a fully charged battery.
"Li-Power" Li-ion battery packs have a capacity and
signal indicator (11):
Press the button (10) and the charge status is indicated
using the LED lights.
If an LED light flashes, the battery pack is almost flat and
must be recharged.
Removing / inserting the battery pack
Removing: Press the button for the battery pack unlock-
ing mechanism (3) and pull the battery pack (6) forwards
and out.
Inserting: Slide the battery pack (6) on until it snaps
into place.
Fault:
Overload protection: The machine was switched off
automatically. The device is too hot!
Leave the machine idling until it has cooled down.

Care and maintenance

Remove the battery from the power tool before trans-
porting, storing or performing any work on the power
tool (e.g. maintenance, tool change, etc.). There is a risk
of injury if the ON / OFF switch is pressed accidentally.
Clean the machine and paddle immediately after use.
We recommend the Collomix MIXER-CLEAN cleaning
bucket to clean the paddle.
Remove the paddle from the coupling after finishing
the work.
Keep the HEXAFIX coupling clean and running well.
Regularly lubricate the hexagonal support of the cou-
pling with suitable lubricant.
The ventilation openings must be kept clean and clear to
ensure sufficient cooling. Blocked
ventilation openings will lead to
the destruction of the device.
Fett
Grease
Make sure that the On/Off switch
Graisse
moves smoothly and that it is
Smar
unlocked.
The machine is fitted with carbon
brushes that switch off automat-
ically. The machine switches off when the minimum
length is reached. Have the carbon brushes replaced
by the authorised customer service department or
Collomix plant service team.
Repairs must only be carried out by authorised work-
shops or by the Collomix Service department.
Only use original Collomix or CAS battery packs and
accessories.
Only buy battery packs with a voltage that matches your
power tool.
Exploded drawings, spare parts lists and the form to
request repairs can be found at: www.collomix.com
Disposal
The device, accessories and packaging should be intro-
duced into an environmentally friendly recycling system.
For EU countries only:
Do not dispose of power tools together with
household waste.
According to EU Directive 2002/96/EC
on waste electrical and electronic equip-
ment and your country's transposition into
national law, power tools that are no longer usable
must be collected and sent to an eco-friendly recycling
facility.
Special instructions for cordless machines:
Battery packs must not be disposed of together with
household waste! Return defective or used battery
packs to your dealer!
Do not throw battery packs into water!
Discharge the battery pack in the power tool before
disposal. Protect the contacts against short-circuit (e.g.
insulate with adhesive tape).