Using For The First Time; Care And Maintenance; Warranty; Ce Declaration Of Conformity - Collomix CX 22 DUO Bedienungsanleitung

Using for the first time

Always hold the machine with both hands.
Press the starting lockout button (1). Press the ON/OFF switch (2). The integrated electronic
controls will start up the machine in a controlled fashion. The more pressure you apply to the
ON/OFF switch, the faster the machine will run.
To stop working, release the ON/OFF switch.
Machines with 2-speed gear units have two maximum speeds available (First gear: Slow / Second
gear: Fast). To change from one gear to the other, turn the gear selection lever through 180°.
Always reduce the speed when submerging the mixing tool in the mixing material or lifting it
out. Once the mixing tool is fully submerged, increase the speed again to ensure that the motor
is adequately cooled.
During mixing you should guide the machine around the mixing container. Continue mixing until
all of the mixing material is completed mixed.
To set the machine down, stand the guard handle upright with the edge on the ground/floor.
Always clean the mixing tools when you have finished your mixing work.
To remove the mixing tools, slide back the collars on the HEXAFIX coupling and pull out the mixing
tools.

Care and maintenance

Before you carry out any operations on the machine, including changing the mixing tool, always
pull out the mains plug first.
Keep the machine and mixing tools clean. Also keep the quick-action coupling clean and free of dust, and
apply a little grease to the hexagon mount at regular intervals. Malfunctions may result if penetrated by
dust.
Keep the ventilation slits (4) clean so that the machine can be properly cooled.
The machine is equipped with self-deactivating carbon brushes. This means that the machine will shut itself
down once a certain level of wear is reached. The carbon brushes can be replaced by an authorized customer service
center or by the Collomix Service center.
Have repairs carried out only by an approved workshop or by your Collomix Service. Only use original Collomix
replacement parts.

Warranty

The manufacturer provides a warranty within the framework of his terms and conditions of delivery in accordance with
the requirements of statutory/country-specific provisions.
Should you need to make a claim under the warranty, please provide us with your invoice or delivery note.
On no account will any warranty claims be accepted if any repairs are carried out by third parties. In the event of any
irregularities, please send the machine to us.
The warranty does not apply to damages caused by natural wear, overloading or improper handling.
Complaints can only be accepted if the device is sent to the Collomix Service center undismantled.
Disposal
The device, accessories and packaging should all be consigned for environment-friendly recycling.
Unusable devices can be sent for recycling, paid delivery home, to the address shown below.
CE - Declaration of Conformity
We declare, with sole responsibility, that this product complies with the following standards or normative products:
EN 55014; EN 61000, EN 60745-1 in accordance with the provisions of directives 2006/95/EC, 2004/108/EC,
2006/42/EC.
Technical file at: Collomix Rühr- und Mischgeräte GmbH, Abt. Technische Entwicklung, Daimlerstr. 9,
85080 Gaimersheim, Germany
Alexander Essing
Subject to change
ON/OFF switch
Gear selection lever