Operation - Collomix Xo 20 NC Originalbetriebsanleitung

• Only start/stop the device in the mixing vessel. Ensure
that the mixing vessel has a firm and secure footing.
• Do not reach with your hand or objects into the mix-
ing vessel during ongoing mixing operation. Risk of
crushing!
• Wait, until the device and/or tool comes to a complete
standstill. Rotating tools can get stuck and cause inju-
ries or damage.
• If the sound pressure level in the workplace exceeds
85 dB (A), wear hearing protectors!
• It is recommended to wear work gloves and protec-
tive goggles when working with the mixer. Wearing
close-fitting clothing is a requirement.
• Wearing a dust mask is recommended to protect
against potentially harmful dust during mixing. Some
mineral substances are carcinogenic. Use a vacuum
cleaner where possible.
L
Special safety instructions for cordless machines:
• Protect battery packs from moisture!
• Do not expose battery packs to fire!
• Do not use defective or deformed battery packs!
• Do not open battery packs!
• Do not touch or short-circuit the battery packs' con-
tacts!
• A slightly acidic, flammable liquid may escape
from defective Li-ion battery packs!
• If battery fluid escapes and comes into contact
with the skin, rinse immediately with plenty of
water. If battery fluid comes into contact with
the eyes, rinse thoroughly with clean water and
seek immediate medical attention!
Transporting Li-ion battery packs:
• The shipment of Li-ion battery packs is subject to
hazardous goods legislation (UN 3480 and UN 3481).
Clarify the currently valid regulations when sending
Li-ion battery packs. Ask your transport company for
information if necessary.
• Only send battery packs if the housing is undamaged
and no fluid is escaping. Remove the battery pack
from the machine for shipping purposes. Protect
the contacts against short-circuit (e.g. insulate with
adhesive tape).
• Remove the battery from the power tool before trans-
porting, storing or performing any work on the power
tool (e.g. maintenance, tool change, etc.).
8
Wear protective googles and hearing protec-
tors when working.
It is recommended to wear a dust mask dur-
ing work involving large amounts of dust.
Wear protective gloves when working.
Assembly HEXAFIX / paddle
Screw the HEXAFIX coupling enclosed with the packag-
ing onto the agitator shaft's 5/8" external thread.
Insert the mixer with HEXAFIX holder shaft into the
coupling until it snaps into place.
To remove or change the mixer, just pull the sleeve on
the coupling and the mixer will be released.
Keep the HEXAFIX coupling clean and grease it from
time to time. This maintains its functionality.

Operation

Always hold the machine with two hands.
Switching on
Press the button for the switch-on
1.
lock (1). The switch is unlocked.
Press the ON / OFF button (2).
The more firmly the ON / OFF
switch is pressed, the faster the
machine runs.
2.
The ON / OFF switch cannot be
locked!
It is best to work with the ON / OFF switch fully
depressed at all times.
Switching off
Release the ON / OFF switch to finish the work.
This machine has a 2-speed gearbox.
Two maximum speeds (1st gear low speed, high torque
/ 2nd gear high speed) are available.
Turn the gear selector by 180° to
change from one gear to another.
Only operate the gear selector
when the device is stopped.
Prevent accidental start-up: always
switch the machine off if the bat-
tery pack is removed from the
machine.
EN