Cutting Hair; Hair Trimmer Attachment; Trimming A Beard; Beard Trimmer Attachment - Silvercrest HAIR & BEARD TRIMMER Bedienungsanleitung

6.4 Cutting hair

Hair trimmer attachment
NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depending
on the cutting angle.
• Place a sheet or cape around throat and
neck to prevent cut-off hair from drop-
ping into the collar.
• Comb the hair well.
• First, start with a comb attachment 2
with a longer cutting length and then, in
the course of the cutting process, use
shorter cutting lengths step by step.
• Start by cutting the hair in the neck or
on the sides and cut towards the centre
of the head. Then, cut the front section
of the hair towards the centre of the
head.
• Hold the hair and beard trimmer 5 in
such a way that the comb attachment 2
lies as flat as possible on the head.
Move the device evenly through the
hair.
• If possible, cut against direction of hair
growth.
• In order to catch all the hair, move the
hair and beard trimmer 5 several times
through each section of the hair.
• Comb the hair repeatedly and well.
• Using the switch for cutting length fine
tuning 6 the cutting length can be slight-
ly varied with three levels (1, 2, 3:
0.7 mm – 1.7 mm).
• In order to achieve a straight cutting line
for cutting lengths over 12 mm, the hair
and beard trimmer 5 should be passed
through the hair several times from dif-
ferent directions.

6.5 Trimming a beard

Beard trimmer attachment
14
NOTE: please note that the cutting lengths
will only be achieved if the switch for cutting
length fine tuning 6 is at position 1 and the
hair and beard trimmer 5 is held at a right
angle to the skin surface.
• Comb the beard in the direction that it
grows.
• Trim the beard downwards from ear to
chin. First trim one side, then the other.
• Comb attachment 1
Figure C: adjust the cutting length with
the slider according to the desired hair
length and read off the cutting length us-
ing the marking on the side of the comb
attachment 1 (3, 4, 5, 6 mm). Now,
shorten your beard step-by-step.
• Use the beard trimmer attachment 15
without a comb attachment 1, to cut the
beard very short or to cut a moustache
and hairline.
• Using the switch for cutting length fine
tuning 6 the cutting length can be slight-
ly varied with three levels (1, 2, 3:
0.8 mm – 1.8 mm).
• To trim your moustache, first comb it
straight downwards. Then use either the
beard trimmer attachment 15 or the
precision trimmer attachment 4. Start at
the centre above the mouth and trim first
one side, then the other.

6.6 Cutting a hairline

Precision trimmer attachment
• Use the precision trimmer attachment 4
to shorten and shape moustaches,
whiskers, sideburns or eyebrows.
• Put the edge of the attachment at the de-
sired hairline height and move the hair
and beard trimmer 5 downwards.
15
4
9
GB