Operation; Transport Safety Lock; Changing The Cutting Attachments; Changing The Comb Attachments - Silvercrest HAIR & BEARD TRIMMER Bedienungsanleitung

6. Operation

NOTE: Figure D: For all applications hold
the shaver with an angle of 45° to your skin.
Regardless of the charging state of the bat-
tery, the 5-in-1 hair and beard trimmer can al-
ways be mains-operated.
1. For mains operation, ensure that the
hair and beard trimmer 5 is switched
off.
2. Connect the power unit 11 to the con-
nector of the hair and beard trimmer 5.
3. Insert the power unit 11 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rating
plate.
4. Switch on the device with the on/off
switch 7.
NOTE: When the hair and beard trimmer
remains connected to the wall socket after
being switched off, it will be charged auto-
matically.

6.1 Transport safety lock

When the transport safety lock is activated,
the lock symbol 10 flashes blue 3 times.
• Press and hold the on/off switch 7 for
approx. 4 seconds to activate/deacti-
vate the transport safety lock.
• By connecting the power unit 11, the
transport safety lock is deactivated, and
also cannot be activated while plugged
in to the power supply.
8
GB
6.2 Changing the cutting
attachments
WARNING! Risk of injury!
Switch off the hair and beard trim-
mer 5, before you attach or remove the
attachments.
• Figure A: to remove the attach-
ments 3, 4, 13, 14, 15 use your
thumbs to press the attachment towards
the rear of the hair and beard trim-
mer 5.
• Figure B: to attach the attachments,
put the lower flap of the attach-
ment 3, 4, 13, 14, 15 into the slot in
the hair and beard trimmer 5 and press
the upper part of the attachment against
the hair and beard trimmer until it audi-
bly locks into place and sits firmly in po-
sition.
6.3 Changing the comb
attachments
Pushing on
• To attach the comb attachments 2 + 1
carefully slide the appropriate comb at-
tachment over the hair or beard trimmer
attachment 14 / 15. Press the lower
part of the comb attachments 2 firmly
until they lock into place.
Removing
• To remove the comb attachments 2 loos-
en the comb attachment at its lower end
and pull it off the hair and beard trim-
mer 5.
• Slide the comb attachment 1 for the
beard trimmer attachment 15 upwards
from the hair and beard trimmer 5.