Shaving; Cutting Hairlines And Beard (2-In-1 Beard And Sideburn Styler) - Silvercrest SRR 3.7 C4 Bedienungsanleitung

6.5 Shaving

DANGER! Risk of electric shock
due to moisture!
The shaver 8 and the power unit 19
are not waterproof and are therefore
not allowed to be used in a shower/
bath.
WARNING!
Do not use the device on open wounds,
cuts, sunburn or blisters.
Do not place excessive pressure on the
shaving heads 4. They are thin and can
be damaged easily.
NOTES:
• Shaving is possible both in battery
mode and in mains operation.
• Initial use may cause temporary irritation
or redness of the skin, as the skin has to
adjust to shaving. This is normal and usu-
ally lasts between 2 to 4 weeks.
Dry shaving (Rechargeable bat-
tery and mains operation)
• Hold the blade unit 4 parallel to the sur-
face of the skin, and gently move it over
your face using circular motions.
• Shave against the direction of your
beard growth.
• Stretch your skin in complicated areas,
such as the chin, to achieve better re-
sults.
• Switch off the device after shaving,
clean the parts carefully (Chapter
"Cleaning and care" on page 26) and
to protect the shaving heads 4, slide
the protective cap 15 onto the shaving
attachment 5 from below.
Wet shaving (only for battery
operation)
DANGER! Risk of electric
shock!
The hand-held device and the power
unit 19 are not waterproof. Wet shaving
is only allowed when using battery power.
WARNING! Risk of material damage!
For wet shaving use shaving foam or
lather only; never use shaving gel or
shaving cream. This could adhere to the
shaving heads 4.
• Before shaving, smooth a thin layer of
shaving foam on your face.
• Shave your face as described in the
chapter Dry shaving (Rechargeable bat-
tery and mains operation).
• If shaving foam should clog the blade
unit with the shaving heads 4, clean the
blade unit under running water (Chap-
ter "Cleaning and care" on page 26).
6.6 Cutting hairlines and
beard (2-in-1 beard and
sideburn styler)
WARNING! Risk of injury!
The points of the beard trimmer attach-
ment 3 are sharp. Handle with care.
• Figure C: adjust the cutting length at
the comb attachment 1 according to
the desired hair length. Read the cutting
length on the side of the comb attach-
ment 1 at the marking 2. The arrow
symbol  16 indicates which cutting
length is set. Now, shorten your beard
step-by-step.
NOTE: ensure that the comb attachment 1
is still firmly attached to the device after ad-
justment.
25
GB