Items Supplied; Charging - Silvercrest HAIR & BEARD TRIMMER Bedienungsanleitung

Do not detach the shaving foil from the
shaving foil frame, and do not clean it
using the brush.
Do not use any astringent or abrasive
cleaning agents.

4. Items supplied

1 5-in-1 hair and beard trimmer 5
1 Power unit 11
1 Battery charger 12
5 Interchangeable cutting attachments:
hair trimmer attachment 14
beard trimmer attachment 15
precision trimmer attachment 4
nose/ear hair trimmer attachment 13
shaving attachment 3
4 Comb attachments 2 for the hair trimmer
attachment 3, 6, 9, 12 mm
1 Adjustable (3, 4, 5, 6 mm) comb attach-
ment 1 for the beard trimmer attach-
ment 15
1 Comb 19
1 Scissors 16
1 Cleaning brush 18
1 Blade oil 17
1 Storage bag (for the hair and beard trim-
mer and its accessories) 20
1 Operating Instructions

5. Charging

NOTES:
• Before first use (without cable), and for
every charging procedure afterwards,
charge the hair and beard trimmer 5 for
approx. 90 minutes.
• The hair and beard trimmer also charg-
es, when it is switched off and connect-
ed directly via the power unit 11 to a
wall socket.
• When the batteries are almost empty,
the plug symbol 9 flashes in red. The
device can then only be used for a short
time without being connected to the
electricity supply.
1. Place the battery charger 12 on a level
surface.
2. Connect the power unit 11 to the bat-
tery charger 12.
3. Switch off the device with the on/off
switch 7 if necessary.
4. Insert the power unit 11 into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
5. Put the hair and beard trimmer 5 into
the battery charger 12.
6. The plug symbol 9 is lit red and the
battery is charged. When the battery is
fully charged, the battery symbol 8
flashes in green. When the battery is
fully charged, the device can be used
for approximately 60 minutes without
being connected to the power supply.
7
GB