BWT AQA therm MOVE Power Einbau- Und Bedienungsanleitung Seite 47

Setting the unit of measure for the outlet water
conductivity value (CONDUCTIVITY UOM)
The product is set to µS/cm at the factory.
The value TDS (Total Dissolved Solids) is spec-
ified in mg/l.
Operating mode (OPERATING MODE)
The respective switch-on and switch-off points set
for pressure production (bar) and the resulting dif-
ferential pressure (hysteresis) are displayed here.
The switch-off and switch-on point for
pressure production are set directly on
the product display.
Reset (RESET)
You can reset the set counter and pump opera-
ting hours here.
To confirm an entry, you must press
. A signal tone confirms the switch
SAVE
to the next level.
A password is required to reset them:
Password "05310" for:
● Inlet water counter (
● Operating days counter
● Outlet water counter (
)
INLET WATER COUNTER
DAYS COUNTER
OUTLET WATER COUNTER
EN
)
47