Ro Systems App; Installing The Bwt Ro Systems App; Display And Settings In The Bwt Ro Systems App; Start Screen - BWT AQA therm MOVE Power Einbau- Und Bedienungsanleitung

EN
8 .1 Installing the BWT RO systems
app
The following conditions must be met:
DAQA therm MOVE Power is connected to the
power supply and switched on.
DA scanner app is installed on the mobile
device.
DThe mobile device has an internet connection.
1. Scan the QR code opposite using a scanner
app. The QR code is located on the rear of
the product.
2. Download the BWT RO systems app.
44
For the iOS version:
► Open the settings on the mobile device.
► Select the "General" menu and open "Device
Management"
► Trust "BWT Holding GmbH".
3. Open the BWT RO systems app.
4. Allow the BWT RO systems app to use
Bluetooth on the mobile device. The product
is automatically displayed in the BWT RO
systems app if it is connected to the power
and within range of the Bluetooth connection
(2 m).
5. Select AQA therm MOVE Power in the list to
establish a connection.
8 .2 Display and settings in the BWT

RO systems app

8 .2 .1 Start screen

The (central) circle button displays the current sta-
tus of the product and the litres per day counter.
The set switch-on and switch-off points for pres-
sure production are indicated by the arrows on the
charging bar.
Product status display – (central) circle but-
ton:
Status Meaning
Product is in operation
WORKING
Product is in standby mode
READY
Product is set to "Pause"
PAUSE
The membrane cartridges are be-
RINSING
ing rinsed (this is done automat-
ically after each production run
and each time that the product is
started)
When one or more service limits
SERVICE
are reached (days, incoming litres,
outgoing litres)
The outlet water conversion factor
W C F -
is below 40% or 30%
ALARM