Troubleshooting - JVC KD-SH909R Bedienungsanleitung

TROUBLESHOOTING

What appears to be trouble is not always serious. Check the following points before calling a service
center.
Symptoms
• Sound is sometimes
interrupted.
• Sound cannot be heard
from the speakers.
• CD-R/CD-RW cannot be
played back.
• Tracks on the CD-R/CD-RW
cannot be skipped.
• "NO DISC" or "EJECT
ERR" appears on the
display and disc cannot be
ejected.
• No message appears on
the display but disc cannot
be ejected.
• When "ERR 00" to "ERR
44" appears on the display.
• This unit or CD changer
does not work at all.
• SSM (Strong-station
Sequential Memory)
automatic preset does not
work.
• Static noise while listening
to the radio.
54
Causes
Contents on the disc are not
compatible with the unit.
You are driving on rough
roads.
Disc is scratched.
Connections are incorrect.
The volume level is set to the
minimum level.
The "P.AMP SW" setting is
set to "OFF."
CD-R/CD-RW is not finalized.
The unit may function
incorrectly.
Something is blocking the
control panel movement.
The built-in microcomputer
may function incorrectly due
to noise, etc.
Signals are too weak.
The antenna is not connected
firmly.
Remedies
Change the disc.
Stop playback while driving on
rough roads.
Change the disc.
Check the cords and
connections.
Adjust it to the optimum level.
Set it to "ON."
(See page 38.)
Insert a finalized CD-R/CD-RW
or finalize the CD-R/CD-RW
with the component used for
recording.
While pressing , press and
hold 0 for more than 2 seconds.
(Be careful not to drop the disc
when ejecting.)
Press the reset button on the
front panel. (See page 2.)
If the reset button does not
work, check the Installation/
Connection Manual (separate
volume).
(Ex.: You have used screws
which are longer than
specified.)
Press the reset button on the
control panel. (See page 2.)
Store stations manually.
Connect the antenna firmly.