JVC KD-SH909R Bedienungsanleitung Seite 50

2
Select the DAB band (DAB1, DAB2,
or DAB3).
D1
(DAB 1)
Note:
This receiver has three DAB bands (DAB 1, DAB 2,
DAB 3). You can use any of them to tune in to an
ensemble.
3
Start searching an ensemble.
When an ensemble is received, searching
stops.
To stop searching before an ensemble is
received, press the same button you have
pressed for searching.
4
Select a service you want to listen to.
50
Each time you press the
button, the DAB band
changes as follows:
D2 D3
(DAB 2) (DAB 3)
Press ¢
to search
ensembles of higher
frequencies.
4 to search
Press
ensembles of lower
frequencies.
1 Press M (mode).
Within
5 Seconds
2 Press ¢
or
4 to select a
service you want.
To change the display information while
tuning in to an ensemble
Normally service name is shown on the display.
If you want to change the display information,
press D (display).
Each time you press the button, the following
information appears on the display for a while.
Service name
Ensemble name
Frequency
Channel number
• Then, the display goes back to the original
indication in several seconds.
To tune in to a particular ensemble
without searching
1
Press SOURCE
the source.
2
Press B (band) repeatedly to select the DAB
band (DAB 1, DAB 2 or DAB 3).
Press and hold ¢
3
than 1 second. "MANU" or "MANUAL*" flashes
on the display.
Press ¢
4
or
ensemble you want is reached.
• If you hold down the button, the ensembles
keep changing until you release the button.
* When the source symbol animation display is not
selected.
&
&
to select DAB tuner as
4 for more
or
4 repeatedly until the