Storing Your Own Sound Adjustments - JVC KD-SH909R Bedienungsanleitung

Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory
(USER 1, USER 2 and USER 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press EQ to activate the sound mode
(EQ).
Each time you press the
button, the sound mode (EQ)
is activated or deactivated.
• When the sound mode
Ex.: When you have selected "POP" previously.
2
Select the sound mode you want.
3
Press SEL (select) to enter
adjustment mode.
The last adjusted frequency and its level appear on
the display.
(EQ) is activated, the last
selected sound mode is
recalled and applied to the
current source.
4
Select the frequency.
5
Adjust the level of the selected
frequency in the step above.
6
Repeat steps 4 and 5 to adjust the
other frequency levels.
7
Select one of the user sound modes
(USER 1, USER 2, USER 3).
8
Press SEL (select) to store the
adjustments.
Note:
If you want to make temporary adjustments and not
store in memory, skip steps 7 and 8. Your temporary
adjustments will remain effective until you select
another sound mode.
• You can select 70 Hz,
150 Hz, 400 Hz, 1 kHz,
2.4 kHz, 6 kHz, and
12.5 kHz.
• You can adjust the
level within the range
of "–05" (minimum) to
"+05" (maximum) for
each frequency.
35