Tuning In To A Preset Station - JVC KD-SH909R Bedienungsanleitung

2
Tune in to a station (in this example,
of 88.3 MHz).
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
Press ¢
to tune
in to stations of higher
frequencies.
4 to tune
Press
in to stations of lower
frequencies.
"1" flashes for a while.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on page 12.
1
Select the band (FM1 – 3, AM).
F 1
(FM 1)
2
Select the number (1 – 6) for the preset
station you want.
If the sound quality decreases and the
stereo effect is lost while listening to
an FM station...
In some areas, adjacent stations may interfere
with each other. If such interference occurs,
this unit can automatically reduce the
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will also be lost.
If you do not want to degrade the sound quality
and to lose the stereo effect, rather than to
eliminate the interference noise, see "To
change the FM tuner selectivity – IF FILTER"
on page 40.
1 Press SOURCE
repeatedly to select
FM or AM (MW/LW) as
the source.
2 If necessary, press B
(band) repeatedly to
select the FM band.
Each time you press
the button, the FM
band changes as
follows:
F 2 F 3
(FM 2) (FM 3)
13