Manual Preset; Tuning In To A Preset Station - JVC ks-lh60r Bedienungsanleitung

Manual preset

You can preset up to 6 stations in each band
(FM1, FM2, FM3, and AM) manually.
Ex.: Storing FM station of 92.5 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
Each time you press the
button, the band changes as
follows:
FM 1 FM 2
(F1) (F2)
2
Tune in to a station (in this example,
of 92.5 MHz).
3
Press and hold the number button
(in this example, 1) for more than
2 seconds.
Selected band/preset number
and "MEMO" (memory) appear
alternately for a while.
FM 3 A M
(F3)
To search stations of
higher frequencies
To search stations of
lower frequencies
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on pages 10 and 11.
1
Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
FM 1 FM 2
(F1) (F2)
2
Select the number (1 – 6) for the
preset station you want.
FM 3 A M
(F3)
11