Manual Preset; Tuning In To A Preset Station - JVC KD-SH9101 Bedienungsanleitung

Manual preset

You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 92.5 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
1 Press SRC (source)
SRC
repeatedly to select the tuner.
2 Press and hold SRC for more
than 1 second.
3 Within about 5 seconds, press
AM
FM1
SRC again.
Each time you press the
FM3 FM2
button, the band changes.
2
Tune in to a station (in this example,
of 92.5 MHz).
Press ¢
stations of higher
frequencies.
Press
stations of lower frequencies.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
The selected preset number
flashes for a while.
1
4
Repeat the above procedure to store
other stations into other preset
numbers.
to tune in to
4 to tune in to
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on pages 12 and 13.
Selecting a preset station directly
1
Select the band (FM1 – 3, AM).
1 Press SRC (source)
SRC
repeatedly to select the tuner.
2 Press and hold SRC for more
than 1 second.
The band indication on the
display starts flashing.
AM FM1
3 Within about 5 seconds (while
the band indication is
FM3 FM2
flashing), press SRC again.
Each time you press the
button, the band changes.
2
Select the number (1 – 6) for the preset
station you want.
1 2 3 4 5 6
13