Setting The Spring Force; Demounting; Disposal; Accessories - Dräger Polaris 50 Montage- Und Gebrauchsanweisungen

12.1

Setting the spring force

CAUTION
The spring force is set at the optimum setting in
the factory

Pull cover off sideways
Set the spring force 1:

+ increase (if the cantilever arm lowers by
itself)

- reduce (if the spring is set too high) until the
desired stability is reached

Put cover back on sideways
13

DEMOUNTING

DANGER
Electric shocks are life-threatening.

Remove connector from the power supply
and put the switch in the "OFF" position
before demounting.
DANGER
Never unscrew the upper cable holder -
injury hazard.

When both cable holders are unscrewed,
the connecting piece is loose and falls
downward, which could lead to injury and/or
damage to the cable and/or the device.
13.1

Disposal

Do not dispose the luminaire and/or
lamp in household refuse. Dispose the
luminaire and/or lamp at a disposal
point in accordance with local
regulations or take them to a dealer
that provides an appropriate disposal
service.
Cut off the cable directly on the
housing.
The products listed above are more
than 95% recyclable. The luminaires
have been constructed to be
compatible with recycling so that a high
proportion of the materials used in
these products can be recycled or
converted into energy after the end of
service life. They contain no materials
that are dangerous or that need to be
monitored.
14

ACCESSORIES

Hand grip (order no. G27960)
15 ADDITIONAL
INSTRUCTIONS
The luminaire itself is maintenance-free.
You can obtain additional documents about this
product from the manufacturer upon request.
These luminaires do not affect any other devices.
To save energy, the luminaire should only be
switched on when actually needed.
EN_GB
37