Storage; Technical Data; Removing The Sweeping System; Transport - Kärcher MC 130 Plus Bedienungsanleitung

Adjusting the side inclination
Screw 1
1
Screw 2
2
2. Unscrew the screws.
3. Adjust the side inclination via the rotation point of screw 1.
4. Tighten the screws.
Adjusting the head inclination forwards
Lock nut
1
Hexagon
2
5. Unscrew the counternut.
6. Adjusting the head inclination via the hexagon.
7. Tighten the counternut.
Adjusting the brush contact pressure
8. The brush system has a hydraulic brush contact pressure ad-
justment system.
WARNING
Risk of injury and damage
Note the weight of the device.
ATTENTION
Risk of damage
Store the attachment kit in a protected, level and dry place. En-
sure that the sweeping brushes are not loaded.
1. Store the sweeping system that has been removed from the
vehicle on the changing carriage.
2. Ensure that the sweeping brushes are not loaded during at-
tachment to the vehicle.
98

Storage

Dimensions and weights
Length
Width
Height
Weight (transport weight)

Removing the sweeping system

Remove the sweeper system in the reverse sequence to the at-
tachment procedure. Set the sweeping system down on the pal-
let. Remove the sweeping brushes first.
Always first depressurise the system before disconnecting the
hydraulic hoses, see the corresponding section in the vehicle op-
erating instructions.
DANGER
Risk of injury due to incorrect transport
Mind the weight of the vehicle.
Slowly and carefully drive the vehicle onto the transport vehicle.
ATTENTION
Damage to vehicle
Do not load the vehicle with the crane.
Do not use a forklift.
1. Slowly drive the vehicle onto the transport vehicle.
Note
If the vehicle is not ready for running, see Chapter Towing the ve-
hicle.
Fastening the transport lock to the articulated joint
Bolt with safety cotter
1
Transport lock
2
Transport lock storage
3
1. Pull out the safety cotters.
2. Pull out both bolts.
3. Remove the transport lock out from storage.
4. Attach the transport lock.
5. Insert the bolts.
6. Lock the bolts with safety cotters.
English

Technical data

3-brush sweeper
system
1800 mm
1250 mm
850 mm
285 kg

Transport

Loading the vehicle