Fuses; Storage - Kärcher MC 130 Plus Bedienungsanleitung

Cleaning the recycling water valve
Bayonet connection
1
Recycling water valve
2
Waste container
3
1. Empty the waste container.
2. Raise the waste container.
3. Open the bayonet connection.
4. Remove the valve.
5. Clean the valve under running water.
6. Insert the valve.
7. Close the bayonet connection.
The fuses are located behind a cover behind the driver's seat.
Cover
1

Fuses

2
1. Open cover.
2. Replace defective fuses.
Note
Use only fuses with the same ampere rating.
Fuses
Fuse Function
F1 Fuel valve
CR* control unit
F2 BODAS control unit, display
F3 Limiter lamp
Interior lighting
F4 Spray pump
F5 Warning flasher system
F6 Rear fog lamp
F7 Left limiter lamps
F8 Right limiter lamps
F9 Windscreen wiper
Differential lock
F10 Radio
High-pressure cleaner
F11 Travel direction indicator
F12 Flashing beacon
F13 Driving pump, indicator
F14 Motor
F15 CR* exhaust gas return valve
F16 CR* air volume sensor
F17 Headlights
F18 Work lights
F19 Cabin ventilation
F20 Seat heater
Mirror heater
F21 Cabin accessories
Front connector, attached equipment
F22 Seat compressor
Rear connector, distributor
F23 Start switch (ignition switch)
F24 Windscreen heater
F25 Preheating
F26 BODAS control unit
F31 Main fuse at the engine
* CR = Common Rail motor (MC 130 Advanced plus)
WARNING
Risk of injury and damage
Note the weight of the device.
1. Park the vehicle in a safe, level and dry place, leave the main
switch on.
2. Change the motor oil and the oil filter.
3. If frost is expected, check if there is enough antifreeze in the
coolant.
4. Empty the water container and the pipe system.
5. With a recycling system (option), drain the water out of the
waste container.
6. Switch off at main switch.
7. Clean the inside and outside of the vehicle.
8. Jack up the vehicle if it is in storage for more than one month.
9. Disconnect battery.
English

Storage

A
30
5
10
7.5
15
5
5
5
10
7.5
10
10
7.5
5
5
5
15
15
15
15
15
30
5
30
40
30
70
109