Adjusting the head inclination forwards
Lock nut
1
Hexagon head
2
5. Unscrew the counternut.
6. Adjusting the head inclination via the hexagon.
7. Tighten the counternut.
Adjusting the brush contact pressure
8. The brush system has a hydraulic brush contact pressure re-
lief system.
WARNING
Risk of injury and damage
Note the weight of the device.
ATTENTION
Risk of damage
Store the attachment kit in a protected, level and dry place. En-
sure that the sweeping brushes are not loaded.
1. Store the sweeping system that has been removed from the
vehicle on the changing carriage.
2. Ensure that the sweeping brushes are not loaded during at-
tachment to the vehicle.
Technical data
Dimensions and weights
Length
Width
Height
Weight (transport weight)
Removing the sweeping system
Remove the sweeper system in the reverse sequence to the at-
tachment procedure. Set the sweeping system down on the pal-
let. Remove the sweeping brushes first.
Always first depressurise the system before disconnecting the
hydraulic hoses, see the corresponding section in the vehicle op-
erating instructions.
Storage
2-brush sweeping sys-
tem
(pulled)
950 mm
1250 mm
750 mm
115 kg
3-brush sweeping system attachment kit
Installing the sweeping system
The pallet on which the sweeper system is delivered is also used
as a mounting aid for attachment/removal.
Pallet
1
Sweeping system
2
1. Move the lift truck under the pallet with the positioned sweeper
system.
Holder on the vehicle
1
Suction mouth installed
2
Sweeping system
3
Pallet
4
2. Pull the locking lever upwards.
3. Position the sweeper system approximately 10 cm in front of
the vehicle.
4. Connect the hydraulic hoses, paying attention to the colour
coding.
The connection assignments are described in a later chapter
5. Connect the water hoses.
6. Plugging in the electrical socket plug connection on the vehi-
cle.
7. Insert the sweeper system into the vehicle mounting bracket,
all the way to the end stop.
8. Lock the sweeper system by pressing the locking lever down
(using the curved rod).
9. The locking mechanism must be adjusted correctly via the ad-
justing nuts when the system is attached for the first time or
transferred to another vehicle. When correctly adjusted, the
locking mechanism must engage when pressed down beyond
the dead point.
10.Attach the side brushes and front brush.
English
(front brush)
95