Kärcher MC 130 Plus Bedienungsanleitung Seite 91

(1)Rod
(2)Locking lever
3. Unlock the sweeping system by inserting the rod and pulling
the locking lever upwards.
The rod needed for this is clamped in a holder between the
driver's seat and passenger seat.
4. Use the lift truck to move the changing carriage centrally in-
wards as far as it will go.
Move the last distance (centring process) faster.
Note
Risk of damage! Watch out for cables and hoses.
5. Raise the lift truck until the changing carriage makes contact
with the sweeper system.
Side brush arm
1
End stop
2
6. Retract both side brush arms.
7. Check the side brush arms for correct seating.
8. Depressurise the hydraulic system. See chapter Depressur-
ise the hydraulic system (pressure relief).
9. Set the ignition to position 1 in working mode (do not start the
engine).
The brushes lower and the hydraulic system depressurises.
10.Disconnect all connections and joints.
11.Remove the suction hose between the waste container and
suction mouth.
12.Disconnect the (thick) water hose.
13.Move the sweeper system out using the lift truck.
Storage box
1
Cables and hoses
2
14.Place the cables and hoses in the storage boxes.
15.Park the sweeper system in a safe place.
16.Extend the lift truck.
Installing the sweeping system
Signal plug for attachment device detection
1
Left side brush connections (hydraulics and water)
2
Sweeping system lock
3
Right side brush connections (hydraulics and water)
4
1. Stop the vehicle on level, solid ground and secure it against
rolling away.
English 91