Working With The Manual Suction Hose (Ex-Factory Option); Attachments - Kärcher MC 130 Plus Bedienungsanleitung

Installation declaration
We hereby declare die technical documents according to EC Di-
rective 2006/42/EC (+2009/127/EC) Annex VII Part B have been
created for the incomplete machine described below and that this
conforms to the following points of the directive:
Annex I Points 1.1, 1.2, 1.3, 1.4, 1.5, 1.6 and 1.7. I Point 1.1,
This declaration is invalidated by any changes made to the in-
complete machine that are not approved by us.
Product: Attachment kit
High-pressure cleaner
Type: 2.851-952.7
Harmonised standards used, based on:
EN 60335–2–79
Authorities can request the relevant documentation for the in-
complete machine from the documentation supervisor. Docu-
ments are provided via email.
Before commissioning or installation of the incomplete machine,
it must be ensured that the complete machine into which the in-
complete machine is installed conforms to the EC Machinery Di-
rective 2006/42/EC (+2009/127/EC).
Please refer to the EC Declaration of Conformity for the machine
for more information on this.
The signatories act on behalf of and with the authority of the com-
pany management.
H. Jenner
Chairman of the Board of Management
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2017/07/18
Working with the manual suction hose (ex-factory
Filling nozzle, water reservoir
1
Suction hose (125 mm)
2
Lock
3
Handle (adjustable)
4
Switch lever
5
Pulled out: Vacuuming with the suction hose
Pressed in: Work in sweeping mode
Manual suction pipe
6
Cover
7
86
S. Reiser
Director Regulatory Affairs & Certification
option)
Suction hose bracket
8
Water hose stowage compartment
9
Water hose
10
Working with the manual suction hose
1. Remove the manual suction hose from the stowage compart-
ment.
2. As necessary:
Connected the water hose provided and open the stop cock le-
ver on the handle.
Close the dosing knobs in the cabin to prevent the emission of
spray water for the suction mouth and sweeper jets, otherwise
there will not be enough spray water for the manual suction
hose.
3. Pull out the switch lever into the "Vacuum with suction hose"
position.
Vacuuming with the manual suction hose
1. Start the motor.
2. Switch on the PTO (at the arm rest control panel).
3. Switch on the blower.
4. As necessary: Switch on the water pump at the control panel.
5. Select the engine speed.
Note
The suction performance depends on the engine speed selected.
1600 rpm - for light waste
2200 rpm - for normal waste
2500 rpm - for strong, heavy waste
6. Hold the suction pipe by the handle (adjustable) and begin
vacuuming.
Storage of the manual suction hose
1. Set the engine speed to 2200 rpm for installing the manual
suction hose.
2. When using the water hose: Switch off the water pump, dis-
connect the water hose and stop appropriately.
3. Insert the suction pipe with handle, press against the cover
and fasten in position.
Note
The vacuum pulls the suction pipe against the cover and the suc-
tion hose contracts. This is necessary to allow it to be stowed in
the bracket.
4. Press the rest of the suction hose into the bracket and press
the flap closed until the latch engages.
5. Switch off the blower.
6. Press in the switch lever into the "Work in sweeping mode" po-
sition.
Note
Please read the attachment operating instructions before fitting
an attachment.
Attachments are optional and can be fitted to the front power lift
(see chapter Front power lift (option)) or to the front or rear
mounting frames.
DANGER
Danger due to change to vehicle's centre of gravity and to
driving characteristics. When transporting fluids, sloshing
motion may occur, which will then rock the vehicle.
In the case of modifications, particularly when converting from
winter to summer use and in the case of changes to load condi-
tions, the driver must be prepared for the change in driving char-
acteristics.
WARNING
Risk of crushing when attaching attachments
Do not reach between the front power lift and the attachment.
CAUTION
Risk of burns from hot hydraulic couplings
Wear protective gloves when disconnecting the hydraulic cou-
plings.
English

Attachments