Risk Of Injury - Kärcher MC 130 Plus Bedienungsanleitung

Charging the battery
DANGER

Risk of injury!

Only charge the battery with the appropriate charger.
Observe the safety instructions on the handling of batteries.
Follow the operating instructions of the charger manufacturer.
1. Disconnect the minus terminal at the battery.
2. Connect the charger to the battery.
3. Insert the mains plug and switch on the charger.
4. Charge the battery with as small a charging current as possi-
ble.
5. After charging, first disconnect the charger from the mains and
then from the battery (minus pole first).
6. Reconnect the battery.
Clean/replace the air filter (MC 130 plus)
Lock
1
Air filter housing
2
Wing screw
3
1. Remove the right-hand side motor cladding.
2. Unscrew the wing screw approx. 2 turns
3. Pivot the complete air filter unit outwards as far as it will go.
4. Screw the wing screw tight.
5. Open the locks (3x) on the air filter housing.
6. Remove the air filter housing.
Air filter housing
1
Filter cartridge
2
Safety cartridge
3
7. Pull out the filter cartridge and safety cartridge.
8. Clean the entire interior of the air filter housing.
9. Knock the dust out of the filter cartridge on a hard surface.
Do not blow out the filter cartridge with compressed air.
10.Replace the safety cartridge with a new one.
Do not re-use a used safety cartridge.
11.Check that the filter cartridge and sealing surfaces are clean
and undamaged.
Replace a heavily soiled or damaged filter cartridge with a new
one.
12.After assembly, pivot the complete air filter unit inwards and
tighten it using the wing screw.
Changing the dust filter on the outer cabin
Cover
1
Dust filter
2
Note
Fine filter filter grade F8 (available as option)
1. Unscrew the 6 screws for the cover.
2. Remove the cover.
3. Take out the dust filter.
4. Blow out the slightly contaminated dust filter using com-
pressed air (reduced pressure). Renew severely contaminat-
ed dust filter.
5. Insert the new or cleaned filter.
Replace the dust filter in the cab interior
Driver's seat
1
Dust filter
2
Passenger seat
3
1. Push both seats forwards.
2. Remove the dust filter.
3. Check/clean the dust filter, replace if necessary.
Installation information
Ensure the correct mounting position on re-installation.
DANGER
Risk of fatal injury from flowing road traffic
Bring the vehicle out of the hazard zone of flowing road traffic be-
fore starting any repair work.
Switch on the warning flashers.
Erect a warning triangle.
Don warning clothing.
Note
Use a suitable, commonly available jack.
English
Changing a wheel
105