Installation Information - Kärcher MC 130 Plus Bedienungsanleitung

Lowering the tipping device
ATTENTION
Damage to the suction hose
When lowering the tilting frame, make sure that the suction hose
goes into its guide properly.
Suction hose
1
1. Lower the tilting frame after removing the safety support.
2. If necessary, manually insert the suction hose into the guide.
Removing the side cladding
WARNING
Risk of burns!
Allow the vehicle to cool down sufficiently before removing any
panels.
Side panel latches
1
Side panel
2
Switchover valve cover
3
1. Remove the switchover valve cover.
2. Set the switch lever to the "Lifting platform" position, see chap-
ter Waste container/attachment frame switchover.
3. Raise the lifting platform approx. 15 cm.
4. Open both side cladding locks.
5. Lift the side cladding upwards and take it off sideways.

Installation information

Installation is performed in reverse sequence.
Removing/installing the radiator protective grille
1. Lift the radiator protective grille upwards.
2. Pull out the lower part.
3. Remove the radiator protective grille downwards.
Installation information
Engage the radiator protective grille at the bottom, then snap shut
at the top.
Checking the coolant level and topping up the coolant
CAUTION
Risk of burns on account of hot components
Do not open or touch the radiator or parts of the cooling system
while the motor is hot.
ATTENTION
Damage to property due to incorrect coolant
Only top up coolant when the motor is cool.
Use water-based anti-freeze.
Do not mix different anti-freeze types.
Only used softened water.
For coolant refer to chapter Technical data.
Cover
1
Upper filling level marking
2
Expansion reservoir
3
Lower filling level marking
4
1. Check the filling level when the engine is cold.
2. Remove the left side panel.
English 103