Passenger Seat; Setting The Steering Wheel Position; Refuelling; Refuelling With The Fuel Canister - Kärcher MC 130 Plus Bedienungsanleitung

Passenger seat

The passenger seat is horizontally adjustable, pull the lever up-
wards to adjust.

Setting the steering wheel position

DANGER
Danger of accident
Only adjust the position of the steering wheel when the device is
standing.
Steering wheel height adjustment locking lever
1
Steering wheel inclination adjustment lever
2
1. Pull and hold the inclination adjustment lever and set the
steering wheel to the desired inclination.
2. Push in the lever.
3. Release the height adjustment locking lever and set the steer-
ing wheel to the desired height.
4. Lock the locking lever.

Refuelling

DANGER
Risk of explosion
Do not refuel in confined spaces.
Do not smoke and avoid open flames.
Ensure that no fuel gets on hot surfaces.
1. Switch off the ignition.
2. Open the tank cap.
3. Fill with fuel.
Only the fuel specified in the operating instructions may be
used.
4. Wipe of any spilt fuel and close the tank cap.

Refuelling with the fuel canister

Estimate the required amount of fuel in advance to avoid over-
flows.

Filling the water reservoir

Filling nozzle
1
Symbol for the "Fill" lever position
2
Symbol for the "Closed" lever position
3
Switch lever
4
Filling level display
5
1. Open the cap on the filling nozzle.
2. Switch lever in the "Fill" position.
3. Fit a water supply hose onto the filling nozzle.
4. Fill the water reservoir.
Note
To prevent back suction, the water hose must not be inserted into
the water reservoir when filling.
5. Close off the water inlet.
6. Remove the water supply hose.
7. Close the cap on the filling nozzle.
8. Switch the switchover lever to the "Closed" position.
Filling the water reservoir for a water circulation
system/recycling mode (option)
With a water circulation system (Recycling mode), water is direct-
ly filled into the waste container.
Water filling connection (GEKA)
1
Right-hand panel
2
Water drain (fill height)
3
1. Unlock the right-hand panel and pivot it outwards.
2. Remove the lock from the water filling connection and water
outlet.
3. Connect the water hose to the water filling connection
4. Fill the waste container with water (max. 100 litres) until water
escapes from the open water drain.
5. Reattach both locks.
6. Close the panels.
7. Switch on recycling mode at the control panel.
DANGER
Danger of crushing
Make sure that no persons are present in the vicinity of the artic-
ulated joint or vehicle during operation.
When using the vehicle for towing, make sure that no persons are
located during operation between vehicle and trailer.
CAUTION
Risk of burns
Only use the vehicle if all panels are attached.
ATTENTION
Risk of damage due to overheated hydraulic oil or overheat-
ed motor!
In case of excessive hydraulic oil temperature or an excessive
coolant temperature, set the motor speed to idle mode (do not
switch off the motor).
Perform the measures in the "Malfunctions" section
ATTENTION
Risk of damage due to missing lubrication
If the warning light for the oil pressure lights up during operation,
immediately move the vehicle out of the danger zone, switch off
the motor immediately and rectify the fault.
English

Operation

79