Danger Of Injury - Kärcher MC 130 Plus Bedienungsanleitung

3. Check the filling level in the expansion reservoir.
Note
The coolant level must be between the upper and lower mark-
ings.
4. Top up the coolant if necessary.
5. Also check the filling level in the radiator, see chapter Topping
up the coolant in the radiator.
6. If the expansion reservoir is totally empty, top up the radiator
first.
Checking the hydraulic oil level and topping up the hydraulic
Hydraulic fluid
1
MIN oil level
2
MAX oil level
3
1. Check the hydraulic oil level.
Note
The hydraulic fluid must be between the upper and lower
markings.
2. Top up the hydraulic oil if necessary.
Note
Lacking hydraulic oil can be topped up using a special acces-
sory tool connected to the leakage coupling on the vehicle. If
required, request the order no. at Kärcher or have Kärcher
Customer Service do the topping up.
For the hydraulic oil grade, see chapter Technical data.
Topping up the coolant in the radiator
CAUTION
Risk of burns on account of hot components
Do not open or touch the radiator or parts of the cooling system
while the motor is hot.
ATTENTION
Damage to property due to incorrect coolant
Only top up coolant when the motor is cool.
Use water-based anti-freeze.
Do not mix different anti-freeze types.
Only used softened water.
For coolant refer to chapter Technical data.
1. Remove the waste container, see chapter Removing the
waste container
104
oil
Radiator cap cover
1
Radiator cap
2
2. Tilt up the radiator cap cover.
3. Turn the radiator cap one click and allow the pressure in the
radiator to release.
4. Unscrew the radiator cap when the radiator has depressur-
ised.
5. Slowly fill the radiator all the way to the top without air bubbles.
6. Screw the radiator cap on tight.
7. Refill the coolant expansion reservoir. See chapter Checking
the coolant level and topping up the coolant.
8. Reattach the panel.
Installing/removing the battery
DANGER

Danger of injury

Observe the safety regulations on the handling of batteries.
Minus terminal
1
Plus terminal
2
Support
3
1. Fit the battery into the battery holder.
2. Screw the bracket on the battery base tight.
3. Connect the terminal clamp (red cable) to the plus terminal (+).
4. Connect the terminal clamp (black cable) to the minus terminal
(-).
5. Plug the cover caps onto the terminal clamps.
CAUTION
Always disconnect the minus terminal first when removing the
battery.
Check that the battery terminals and terminal clamps are protect-
ed with a sufficient quantity of terminal grease.
English