Sweeping System - Kärcher MC 130 Plus Bedienungsanleitung

2. Disconnect and remove the suction hose from the waste con-
tainer.
Water connections
1
3. Disconnect the hoses for water recycling, fresh water and the
high-pressure cleaner (optional).
4. Steer the vehicle straight ahead.
Retaining pin for waste container with locking pin
1
Rear parking supports
2
Height adjustment with bolts and retaining clips
3
Safety lever with retaining clips
4
5. Open the locking pin for the waste container from the retaining
pin and remove it.
6. Pull out the retaining pin.
7. Adjust the rear parking supports to an appropriate height and
secure in this position.
a The corresponding height depends on the tyre type and the
tyre pressure.
8. Push in the rear parking supports all the way to the end stops
and secure in this position. To do this, press the safety lever
down and push in the supports as far as they will go. Then se-
cure the safety lever with the retaining clip.
9. Depressurise the hydraulic system, see chapter Depressurise
the hydraulic system (pressure relief).
10.Disconnect the electrical and hydraulic connections from the
waste container.
90
Front parking support
1
Safety lever with retaining clips
2
Brakes
3
11.Set the switchover valve to the tilting attachment frame posi-
tion. See chapter Waste container/attachment frame switcho-
ver.
12.Raise the attachment frame with waste container.
13.Push in the front parking supports as far as they will go and
secure them. To do this, press the safety lever down and push
in the supports as far as they will go. Then secure the safety
lever with the retaining clip.
14.Lower the attachment frame.
15.Actuate the roller brakes on the front parking supports.
Note
The waste container now stands free on the parking supports.
16.Drive the rear of the vehicle carefully out from under the waste
container.
Removing the sweeping system
A changing carriage is required for attaching/removing the
sweeper system.
Note
Optional accessory, order no. 2.852-065.0.
1. Stop the vehicle on level, solid ground and secure it against
rolling away.
2. Raise the side brushes and extend both side brushes out-
wards.
Brush system unlocked lever position
1
Brush system locked lever position
2
Vehicle front
3
English

Sweeping system