Installation; Din Front/Rear-Mount; Installation The Unit - Clatronic AR 759 Bedienungsanleitung

3.

INSTALLATION

•
Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up
properly and the unit and system work properly.
•
Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can
cause malfunctions.
•
Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the
vehicle.
•
Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
•
If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance.
•
Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or
from hot air, from heater, or where it would be subject to dust dirt or excessive vibration.
•
Be sure to remove the front panel before installing the unit.

DIN FRONT/REAR-MOUNT

This unit can be property installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-
mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the fol-
lowing illustrated installation methods A and B.
DIN FRONT-MOUNT (Method A)

Installation the unit

1) Dashboard
2) Holder
After inserting the half sleeve into the dashboard, se-
lect the appropriate tab according to the thickness of
the dashboard material and bend them inwards to se-
cure the holder in place.
3) Screw
1) Dashboard
2) Nut (5mm)
3) Spring washer
4) Screw (4X12mm)
5) Screw
6) Support Strap Be sure to use the support strap to se-
cure the back of the unit in place. The strap can be bent
by hand to the desired angle.
7) Plain washer
42