Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NSTALLATION
6. Mount the sleeve by inserting the sleeve
into the opening of the dashboard and
bend open the tabs located around the
sleeve with a screwdriver. Not all tabs
will be able to make contact, so
examine which ones will be most
effective. Bending open the appropriate
tabs behind the dashboard to secure
the sleeve in place.
Tabs
Screwdriver
7. Reconnect the wire harness and the
antenna and be careful not to pinch any
wires or cables.
8. Slide the unit into the sleeve until it
locks into place.
9. To further secure the unit, use the
supplied metal strap to secure the
back of the unit in place. Use the
supplied hardware (Hex Nut (M5mm)
and Spring Washer) to attach one end
of the strap to the mounting bolt on the
back of the unit. If necessary, bend the
metal strap to fit your vehicle's mounting
area. Then use the supplied hardware
(Tapping Screw (5x25mm) and Plain
Washer) to attach the other end of metal
strap to a solid metal part of the vehicle
under the dashboard. This strap also
helps ensure proper electrical
grounding of the unit.
Note to install the short threading
All manuals and user guides at all-guides.com
Dashboard
10. Reconnect the cable to the vehicle
Sleeve
Removing the unit
1. Make sure the ignition is turned off, then
2. Remove the metal strap attached the
3. Press the release button to remove the
4. Lift the top of the outer trim ring then pull
5. Insert both of the supplied keys into the
27
terminal of the mounting bolt to the back
of the unit and the other long threading
terminal to the dashboard.
Spring Washer
Metal Strap
Mounting Bolt
battery's negative (-) terminal. Then
replace the outer trim ring and install the
unit's front panel (see the steps of
"installing the front panel").
disconnect the cable from the vehicle
battery's negative (-) terminal.
back of the unit (if attached).
front panel.
it out to remove it.
slots at the middle left and right sides of
the unit, then pull the unit out of the
dashboard.
Hex Nut
Plain Washer
Tapping Screw
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
