Installation Tips - Clatronic AR 829 DVD Bedienungsanleitung

Installation Tips:

• Cable protection sleeves protect cables against fraying on
sharp body parts.
• The insulation of the cables must not be damaged during
installation.
• It is essential to use the correct tools when installing car hi-fi.
Depending on the model, your vehicle may deviate from the abo-
ve description. We do not accept any liability for damage caused
by installation or connection errors or for consequential damage.
Installation
Please install the car radio as shown below.
a Nut
b Spring washer
c Plain washer
d Screw
e Mounting bracket
f Slide-in housing
g Threaded bolt
h
NOTE:
Note: Retaining screws
during transport
(please remove before
installation)
i Extraction tool (spanner for
dismantling)
j Frame
First place the operating panel
in position on the right-hand
side and then lock it into place
on the left. Then clip in the
control panel on the top right
hand side until it clicks.
Connection
Connect the device as shown in the diagram.
CAUTION:
• Do not attach the removable control panel until after con-
nection of the cables.
• Please use loudspeakers with an impedance of 4 ohm.
• The loudspeaker cables must be unearthed.
• If a subwoofer is connected, an amplifier is required.
• The earth connection cable (BRAKE) must be connected
in order for DVD pictures to be played back to the monitor.
If the cable has not been properly connected the message
"ATTENTION YOU CAN NOT USE THIS FUNCTION
WHILE DRIVING" appears.
23