Radio Operation; Selecting The Frequency Band; Scan; Station Storing - Clatronic AR 819 BT/USB/Card Benutzerhandbuch

OPERATION

RADIO OPERATION

SELECTING THE FREQUENCY BAND

At radio mode, press BND button (24)
shortly to select the desired band.
The reception band will change in the
following order:
FM1(FM2(FM3(MW(FM1
SELECTING STATION



Shortly press / buttons (1) to activate
automatic seek function. Press for several
seconds until "MANUAL......" appears on
the display, the manual tuning mode is
selected. If both buttons have not been
pressed for several seconds, they will
return to seek tuning
"AUTO......" appears on the display.
AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic memory storing
Press AS/PS button (20) for several
seconds "SEARCH" will appear on LCD.
the radio will search from the current
frequency and checks
strength until one cycle search is
finished. And then 6 strongest stations
are stored into the corresponding preset
number button.
- Program scanning
Press AS/PS button (20) shortly to scan
preset station. And the corresponding
station number P1~P6 will flash on LCD.

SCAN

Press SCAN button (18) to enter scan
mode, the unit will scan to higher frequency
station and keep on each station for several
seconds (the corresponding frequency will
flash 5 times on LCD).

STATION STORING

Searched a station press preset button (1-6)
for several seconds (until 2'nd beeps come
out), current station is stored into the
number button.
All manuals and user guides at all-guides.com
RDS (RADIO DATA SYSTEM)
-
-
mode and
the signal
33
Setting RDS mode
Press AF button (21) and release
immediately to switch on or off RDS
mode.
Whenever RDS is switch on, "RDS" will
flash on LCD.
USE PTY BUTTON (17)
1) Shortly press PTY button (17) will
enter PTY SELECT
program name will be displayed on
the LCD, you can use
select the items and press
buttons (1) to begin search the
corresponding program.
2) Press and hold PTY button (17) will
enter RDS MENU, in the menu, use
/ (25) to select the items and
press / buttons (1) to adjust
corresponding item.
TA-SEEK: SEEK/ALARM
a) TA SEEK mode:
When newly tuned station does not
receive TP information
seconds, the radio retunes to next
station which has not the same
station (PI) as the last station, but
has the TP information.
When TP information gets lost at the
current station for retune time which is
set by RETUNE SHORT or
RETUNE LONG, the radio start to
retune to next same PI station.
When PI station does not catch in
one cyclic search, the radio retunes
to next station with TP information.
Note: In TA SEEK mode, the current
station can be changed to the
completely different station because
the unit searches TP station when
the field (signal) strength of the
current station is very weak, or the
current station has no "TP" signal.
(The higher priority is TP rather than
PI.)
mode, the
/ (25) to
/
for 5