To Use The Product In Collect Mode - Husqvarna RC 318T Bedienungsanweisung

3. Turn the ignition key to the start position.
4. When the engine starts, immediately release the
ignition key to neutral position.
Note: Do not run the starter for more than 5 seconds
at a time. If the engine does not start, wait 15
seconds before you try again.
5. Turn the key to the lights position to make the
headlights come on.
6. Push the throttle control to full throttle position (A).
63 - 005 - 03.02.2017
2
1

To use the product in collect mode

1. Start the engine.
2. Make sure that the symbol on the auger control
button is green. This shows that the product is in
Auger control switch with LED
collect mode. See
indicators on page 6 for information on what to do if
the symbols on the auger control switch lights up or
the auger control button is red.
3. Press the parking brake pedal down and then
release it to release the parking brake.
4. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pressed
down. Use pedal (1) to move forward, and pedal (2)
to reverse.
5. Release the pedal to brake. On model RC 318T, you
can use the speed brake/parking brake pedal to get
A
1
2
17